68
activated, the corresponding warning
lamp will flash synchronously.
• The buzzer is not activated. After the
vehicle is started, when the vehicle
travels forward at a speed of 25 km/h, if
the driver's or front occupant's seat belt
is not fastened or the fastened seat belt
is unfastened, the buzzer will be
activated. The buzzer will stop ringing
until the driver's or front occupant's seat
belt is fastened or the ringing lasts for
more than 120 seconds (the buzzer's
beep will not be interrupted by the
change of vehicle speed).
• The buzzer is not activated, the vehicle
speed decreases from 25 km/h to less
than 10 km/h, and the speed is increased
to 25 km/h again, and the seat belt
unfastened alarm is reactivated.
• The buzzer is activated. When the
driver's or front occupant's seat belt is
unfastened and the alarm conditions are
met, the buzzer will be activated again.
The buzzer sounding time will be
calculated from the second activation.
• When the vehicle is shifted into the
reverse gear, it is shifted into drive gear
again. If the driver's seat belt is not
fastened, when the vehicle speed is
greater than 10 km/h, the buzzer will be
activated until the driver wears the seat
belt or the buzzer lasts for more than 120
seconds.
Wearing the seat belt correctly can
protect the safety of drivers and
occupants in case of emergency braking
and traffic accidents. Therefore, all
occupants should always wear seat belts
correctly when driving.
Please pay attention to the warning
indicator, otherwise serious personal injury
and property loss may be caused.
Safe travel
To Next Page
Loading...
Need help?
General
