Retractive Moonroof Troublesolution
There i s wind
n o i s e i n t h e
moonroof
Clearance
between the
glass panel and
the opening edge
R e m o v e t h e
m o l d i n g s ,
loosen the glass
tigh t e n i ng n u t ,
use a shim to fit
the gl ass panel
i n t o t h e r o o f
opening edge.
I n c o n s i s t en t
heights of the
glass and roof
L o o s e n t h e
tightening, adjust
the glass panel
height.
D a m a g e d s e a l
strip
Replace the
seal strip
Unusual noise in
the guide rail
Foreign object in
the guide rail
Lubricate the rail
Moonroof can not
operate normally
Burned fuse
Replace the fuse
Poor switch
connection
Re p la c e t he
switch
Motor fault
Replace the
motor
Control module
fault
R e p l a c e t h e
control module
Damaged unit
Repaire the unit
Moonroof
Water Leakage
Blocked drain tube
Blow th e dr ain
tube with air gun.
Moonroof has no
anti -clamp and
automatic
closure function
T h e c o n t r o l
module need to
be reset
Remove Moonroof
guard and insert
it 5 seconds later
Problem
Cause
Solution
Maintenance:
If required, the glass cleaner can be used to
clean the glass panel. Please do not use viscous
cleaner!!
Add lubricant into the guide rail regularly
(every 3 month). Do not use butter or viscous
grease.
Automatic Closure Function:
With glass panel in any open position, the
Moonroof will be closed automatically 10
seconds later after the vehicle power supply is
shut off.
Sunshade:
When the vehicle drives at high speed, it is
prohibited to close the sunshade with the
Moonroof opened.
Moonroof Reset:
If the vehicle power supply is frequently shut
off (e.g. replacement of battery), the Moonoof
need to be reset.
Method: turn the ignition key to “ON”, touch
the Retraction Open button and then touch the
Retraction Close button.
29
Part I