Three Point Type Seat Belt Buckle
Adjust the seat on demand and sit in the seat
upright against the seatback. When it is re-
quired to fasten the seat belt buckle, pull out
the buckle from the retractor and insert the tab
into the buckle beside the seat.
After the tab is inserted into the buckle, a click
will be heard.
The length of the seat belt can be automatically
adjusted based on the gure of the passenger
and the position of the seat.
In case of emergent brake or collision, the
retractor will lock the seat belt buckle. Rapid
pull-out could also result in the lock of the
buckle. Slow and smooth action is helpful for
free extension of the seat belt. If you can not
pull out the belt from the retractor, just strainit
for a while and then release it, then the belt can
be pulled out from the retractor smoothly.
In case of a serious collision accident, the
whole assembly of the seat belt buckle
(including bolt) should be replaced even if
it is not apparently damaged.
Seat Belt with adjustable shoulder anchor
(adapt the position of the shoulder anchor to
your body size)
P r e s s t h i s
button to ad-
just upward
a n d do w n -
ward
Lift: Press the button (see the figure above)
and slide the anchor upward.
Descent: press the lock release button and slide
the anchor downward. After the adjustment,
make sure the anchor is locked in place.
Tighten the loose part
Too high
Try to remain low to the hip
34
Part I
To Next Page
Loading...
Need help?
General
