____________________ _
ADL300-EPCv2- User Guide Page 58 of 64
7. REMOTE CONTROL OR VIA I/O
7.1 Introduction
This section describes how to configure the digital inputs and outputs of the ADL300 drive with EPC
application. It includes an example of I/O connection and another of how to send command signals via
fieldbus.
The source of each signal can, however, always be selected separately using parameters, thus also making
different configurations possible (e.g. Menu 05.05 "Lift Command" or 05.06 "Lift Inputs").
7.2 Example of Control via Digital I/Os
AC
PC SH
BR
A1
A2
A1
A2
A1
A2
LIFT CONTROLLER
The table below shows the factory settings for this example:
Commands:
To Next Page
Loading...