EasyManuals Logo

gefran ADL300 EPC v2 User Manual

gefran ADL300 EPC v2
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
____________________ _
ADL300-EPCv2- User Guide Page 5 of 64
INTRODUCTION
This document provides all the information necessary for the design, wiring and configuration of a system
based on the EPC (Elevator Position Control) application in the lift industry using a product from the
SIEIDrive ADL300 series.
It describes the sequences and functions of EPC (Elevator Position Control). The version 2 introduce the
enhancement to manage installations up to 32 floors doubling the previous version where the max number of
floors was 16.
The EPC function is a position regulator for direct, "one shot" arrival at the floor without having to slow down
during the approach.
The control must function on ADL300 drives in all the control modes envisaged (FOC and BRS)
The EPC functions are installed in the ADL300 series of drives as application 2. To enable the function the
558 Application select parameter must be set to 2 (see ADL300-…-FP manual).
For all information about the ADL300 series of drives reference should be made to the “Quick start guide
and Specifications and connection” (ADL300 QS EN manual 1S9QSEN).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the gefran ADL300 EPC v2 and is the answer not in the manual?

gefran ADL300 EPC v2 Specifications

General IconGeneral
Brandgefran
ModelADL300 EPC v2
CategoryIndustrial Electrical
LanguageEnglish