gefran GTF User Manual

580961F_MSW_GTF/GTF-Xtra_07-2018_ENG
400
21 - 29 - 143
tYP.
R/W
Type of probe, signal, enable, custom
linearization and main scale input
0 ...1
0
Unless indicated otherwise,
these parameters are in
decimal format and
represent 16 bit words.
Main Modbus address and additional addresses (if any).
Any second / third Modbus addresses are alternatives to the main address.
Mnemonic code (if any)
R read only (read) and/or W (write) attribute
Description
Supplemental data and/or information on the parameter
Setting limits
Default value
Supplemental data and/or
information
Supplemental data and/or information
dP_S Format
0 xxxx
1 xxx.x
2 xx.xx (*)
Supplemental data and/or
information
68
bit
STATE
DIGITAL INPUT 1
OFF = Digital input 1 off
OFF = Digital input 1 on
Function
R/W
STRUCTURE OF THIS MANUAL
This manual was originally written in ITALIAN. Therefore, in case of inconsistencies or doubts, request the
original manual or explanations from GEFRAN.
The instructions in this manual do not replace the safety instructions and the technical data for installation, conguration and
programming applied directly to the product or the rules of common sense and safety regulations in effect in the country of
installation.
For easier understanding of the controller’s basic functions and its full potentials, the conguration and programming parameters
are grouped according to function and are described in separate chapters.
Each chapter has from 1 to 3 sections:
- the rst section presents a general description of the parameters described in detail in the following zones;
- the second section presents the parameters needed for the controller’s basic applications, which users and/or
installers can access clearly and easily, immediately nding the parameters necessary for quick use of the controller;
- the third section (ADVANCED SETTINGS ) presents parameters for advanced use of the controller:
this section is addressed to users and/or installers who want to use the controller in special applications or in applications
requiring the high performance offered by the instrument.
Some sections may contain a functional diagram showing interaction among the parameters described;
- terms used on other pages of the manual (related or supplemental topics) are shown in underlined italics and listed
in the index (linked to IT support).
In each section, the programming parameters are shown as follows:
These parameters are represented in 1 bit format.
-999...999
Scale points
1000

gefran GTF Specifications

General

Brand	gefran
Model	GTF
Category	Controller
Language	English