gefran KFM05a

3.1.5 Jumper ST3
With this jumper, the logic of the inputs is defined.
FRONT = 24V reference X7:1
BACK = GND reference X7:2, standard
Therewith, the inputs can be adjusted to any controller as described below. The default
configuration (BACK) corresponds to the connection examples.
3.1.6 LED
Status-LED
LED 4 LED 3
LED 2 LED 6
LED 1 LED 5
LED 1 GREEN
option
LED 2 YELLOW
option
LED 3 RED
flashes
error
LED 4 GREEN
option
LED 5 YELLOW
on
enable is set
off
power amplifier disabled
LED 6 GREEN
on
ready
off
reset is set
3.1.7 DIP-Switch
Assignment of the DIP-Switch
S3.1 Modbus-Protocol
S3.2 Special function
S3.3 Fieldbus-controller active
S3.4 Option
S3.5 Configuration Analog Input 1 0 – 10 V / 0 – 20 mA
S3.6 Configuration Analog Input 2 0 – 10 V / 0 – 20 mA
Switch ON  Function active switch to the bottom
Standard all OFF switch to the edge of the board
Switch S3.5 und S3.6 OFF  0 – 10 V voltage input
ON  0- 20 mA current input
SIEI-AREG GmbH
Gottlieb-Daimler-Straße 17/3
74385 Pleidelsheim Germany
Fon: +49 7144 89736 0
Art.-No.: 918 111e
Page 26 von 60
Rev. 09/14