gefran TPD32-EV-CU series

To Next Page

To Previous Page

—————— Instruction manual ——————

Duringstart-upthethresholdfortheundervoltagemessagehastobesetviatheUndervolt thr parameter

(standard:230V).

note!  AccordingtheinputvoltagetheswitchS15.7/8ontheregulationboardmustbesetasfol-

lows:

 TPD32-EV-500/...    S15.7=ON  S15.8=OFF

 TPD32-EV-575/...    S15.7=OFF  S15.8=ON

 TPD32-EV-690/...    S15.7=OFF  S15.8=ON

 TPD32-EV-FC-200/...(fromfw10.21) S15.7=ON  S15.8=OFF

 TPD32-EV-FC-500/...(from fw10.20) S15.7=ON  S15.8=OFF

note!  AsfortheoperationoftheTPD32-EVconvertersACinputreactorsandinterferencesup-

pressionltersarerequired.Seesection4.10,“Reactors/Filters”.

 Theconvertersabove770AandtheACinputreactorshaveadischargecurrentstoground

higherthan3.5mA.EN50178statesthatbesidethegroundconductoranothergroundcon-

nectionshouldbelaid.

Caution!  Duetotheincreaseddischargecurrentinvolved,axedgroundconnection(withoutconnec-

tors)fortheltersoftheTPD32-EVconverterisrequired.

gefran TPD32-EV-CU series - Page 27