gefran TPD32-EV-CU series - Page 332

—————— TPD32-EV ——————
332
Speed demand En Speedreferencecalculationenabled.
Winder side Selectionofthewinding/unwindingside:0=up,1=down
W gain Settingofthespeedreferencegainusedtosaturatetheloop.Parameterasapercentage
oftheincreasing/decreasingvalueoftheangularspeedreference.
Speed match Commandofthecoil“launching”phaseforanautomaticswitching.
Spd match gain Settingofthespeedreferencegainduringthelaunchingphase,100%correspondstoa
peripheralspeedequaltothelinespeed.
Spd match acc Motoraccelerationtimeduringthelaunchingphase,in[s].
Spd match dec Motordecelerationtimein[s]ifduringthelaunchingphaseastopcommandisgiven.
Spd match compl Indicationofacompletedlaunchingramp,ifitisprogrammedonadigitaloutputitcan
beusedtostatethatthecoilcanbechanged.
Spd match torque Settingofthetorquecurrentduringthelaunchingandchangephase.Theparameteris
givenasapercentageofthedriveratedcurrent.
W offset Offsetsettingonthespeedreferencefortheinitialphaseofthewinder/unwinderwhen
thelineisstopped.Theparameterisgivenin[rpm].
Offset acc time Settingoftherampfortheinitialphasewhenthemachineisstopped.Theparameteris
givenin[s].ItreferstoSpeed base value.
W target Parameternumberwherethespeedreferencehastobeaddressedto.Inordertoobtain
therealnumbertobeset,itisnecessarytoadd+2000H(8192decimal)totheparameter
number.
 1. Addressingexampleonthespeedreference2:
   OPTIONMenu
  ————>Torquewinder
     ————>Speeddemand
      ————>Wtarget=8235
 Paragraph10.2.“List of the high priority parameters’ showsthatSpeed ref 2hasthe
decimalnumber43.Inordertoobtainthevaluetobeentered,itisnecessarytoadd
8192decimal(xedoffset):8192+427=8235
W reference Monitorforthespeedreference.
Jog TW enable Jogfunctionenabled.
Jog TW speed ReferencesettingforJogfunction.Theparameterisgivenasa%ofLine speed.