130 918496/GP0313
Lubrication
Important: Use of lubricants not corresponding to manufacturer
recommendations may invalidate warranty claims. Always dispose of waste
lubrication oils and hydraulic fluids according to environmental laws or take to a
recycling center for proper disposal. DO NOT pour fluids onto the ground or
down a drain.
Refer to the following figures for grease fitting locations. See “Fluid Capaci-
ties/Lubricants” on page 31 for proper grease specifications. Wipe dirt from the
fittings before greasing them to prevent contamination. Replace any missing or
damaged fittings. Avoid excessive greasing to minimize dirt build-up.
Figure 102 – AL 500 Series – Grease Every 10 Hours (or daily)
A. All-Tach
®
System Pins (2)
B. All-Tach
®
System Pivots - Lower (2)
C. Lower Link Pivot - Front
D. Upper Link Pivot - Front
E. Lower Link Pivot - Rear
F. Loader Pivot
G. Tilt Cylinder - Front
H. LIft Cylinder - Front (2)
I. Upper Link Pivot - Rear
A
A
B
B
C
E
G
F
I
H
H
D
AL 500 Series (AL 400 Series Similar)
https://tractormanualz.com/
To Next Page
Loading...
