917001/CP0905 31
Lift/Tilt Control
Moving the lift arm and tilting the attachment are accomplished by movement of
the right joystick. To raise the lift arm, pull the control straight rearward; to
lower the lift arm, push the control straight forward. To tilt the attachment for-
ward and down, move the control to the right; to tilt the attachment up and
back, move the control to the left.
Note: The speed of the lift/tilt motion is directly proportional to the amount of
joystick movement and engine speed.
To place the lift arm into the detent (“float”) position, push and hold the left
button on the right joystick. This mode allows the lowered lift arm to move up
and down without moving the T-bar while traveling over changing ground condi-
tions. An indicator light in the left instrument panel will blink when float is acti-
vated.
Never push the float control button with the
attachment loaded or raised, because this will
cause the lift arm to lower very rapidly.
Releasing the float button will cancel the float mode if the button was pressed
less than five seconds. If the float mode button is pressed longer than five sec-
onds, the float feature will stay on and the float indicator lamp will light continu-
ously until the button is pressed again.
WARNING
https://tractormanualz.com/
To Next Page
