Geller ET-6800 - Installing the Receipt Roll; Installing the Journal Roll

6
Installing the Receipt Roll
1. Ensure the Control Lock is in the ‘R’ (Register) position
2. Lift up the printer cover from the rear
3. Insert a new paper roll and sit it in the paper cradle
4. Push the paper through the open paper slot
5. If necessary press the RF button to advance the paper automatically
6. Replace the printer cover and tear off any excess paper
Installing the Journal Roll
1. Make sure the Control Lock is in the ‘R’ (Register) position
2. Lift up the printer cover from the rear
3. Insert a new paper roll and sit it in the paper cradle panel
4. Push the paper through the open paper slot
5. If necessary press the JF button to advance the paper automatically
6. Using the journal take up spool, wrap around the journal roll to this device
7. Replace the printer cover