PROGRAMMING THE ALARM SYSTEM
Has been previously programmed with standard configuration during
manufacturing procedure by Gemini, and can be modified in any moment
With alarm being disarmed, open and keep it open the driver side door.
Turn the ignition key to "ON" position.
The status led stay on for 0,5 seconds; during this time, push together the
two buttons of the remote control.
Starting of programming procedure is indicated by two flash of the turn
signals and of the led.
To able and disable the functions, follow the below table, take into
consideration that every time the push button of transmitter is pressed, the
system goes to the following function.
!
!
!
!
!
During the programming phases, press the radio control (rough) push-button
n.1, for function activation and the (smooth) push-button n.2, for function de-
activation.
For the programming modification proceed as follows:
Coninuous or intermittent
siren sound
Panic alarm or “car finder”
Panic/boot opening function
Setting of centralized lock
times (0,5 - 6 sec)
25 seconds comfort closure
command
Current absorption sensor
Anti-distraction, automatic
door locking function
Nction/boot opening function
Continuous
Disabled
Disabled
0,5” selected
Enabled panic
Disabled
Disabled
Disabled
Panic function
enabled
Button N°1- Intermittent
N°2-
N°1- Enable panic
N°2- Enable
N°1-
N°2-
N°1-
N°2-
Button Continuous
Button
Button car-finder
Button Enable
Button Disable
Button N°1- Enable
Button N°2- Disable
Button Enable
Button Disable
Button N°1- Enable 6”
Button N°2- Enable 0,5”
Button N°1- Enable
Button N°2- Disable
Button N°1- Abilita
Button N°2- Disable
FUNCTION STATE BUTTON
NOTE:
NOTE: automatic activation of engine immobilisation is enabled at the
factory and cannot be changed in the version for the UK market.
“
Once the last function has been programmed, the alarm will confirm that
the programming has been disabled with two flashes of the turn signals,
Turn the ignition key to “OFF” position.
!
!
by turning the ignition key to OFF”, in any moment of the programming
procedure, the latter will stop and successive functions will remain unchanged.
fand two flashes of the LED.
PAG . 8
PAG . 9
To Next Page
Loading...
