How to fix Gemini FlexiPen 120 when the pen is moving but it doesn’t mark the paper?
If the pen is moving but not marking the paper, it could be due to: 1. A dry or empty refill. 2. Insufficient pressing pressure. To fix this: 1. Change the refill. 2. Increase the pressing pressure of the pen.
What to do if Gemini FlexiPen 120 file plotting is stopped?
If a file plotting is stopped, the plotter may be in pause mode. Check if the flashing caution light “Pause” is bright and step out from “Pause” mode.
How to fix if you cannot start the Gemini Plotter plotting program?
If you're unable to start the plotting program, it may be due to troubles during the program installing. Reinstall the program to solve this issue.
What to do if the control panel display is turned-off on my Gemini Plotter?
If the control panel display is off: 1. Check if the charging wire is properly connected to the plotter and plugged into a power source. 2. Ensure the on/off button is in the ON position. 3. Inspect the fuse and replace it if it's interrupted.
What to do if the message “Welcome to use CAD Plotter” is not displayed when you turn on the Gemini Plotter?
If the welcome message isn't displayed when you turn on the plotter, especially after recently turning it off, turn off the plotter and then turn it on again after waiting at least 10 seconds.
Crucial safety notice advising users to read the guide carefully before operation.
Details the technical data and specifications for the Flexipen 120/165 plotters.
Provides advice on power supply, serial cable, antivirus, and serial port usage.
Outlines the essential steps for setting up the plotter for the first time.
Identifies and labels the various physical parts of the plotter.
Details the process of assembling the plotter from its delivered packages.
Explains the procedure for connecting the plotter to a power source and its startup.
Details the plotter's control panel, including display, keys, and indicators.
Provides instructions for placing the paper roll onto the feed spindle correctly.
Explains how to attach the paper to the recovering reel spindle.
Details the refill device and how to mount it onto the writing head.
Instructions on inserting standard and 3 ml 'JUMBO' refills into the writing device.
Step-by-step guide for installing the plotter's software on a computer.
Overview of the software's interface, menus, and basic functionalities.
Details on configuring program settings, plotter type, and optimization options.
Guides on calibrating the plotter for accuracy and initiating the plotting process.
Details lubrication and cleaning schedules for plotter components.
Recommends frequency for recalibration and methods for checking plotting quality.
Lists typical problems with the control panel, power, and plotter response.
Addresses software startup problems and issues affecting plotting output quality.
To Next Page
General