Genelec GLM 4 - Woofer System Calibration

15
3. Click the ‘Conrm Calibration’ button to accept and
save the calibration to the setup le. If there are
several subwoofers in the group, the AutoPhase
will move to the next subwoofer automatically.
Figure 8. Steps in running the AutoPhase automatic phase
calibration process.
3.11 WOOFER SYSTEM CALIBRATION
For a system containing Adaptive Woofer Systems, the
rst part of the calibration (calibrating the main monitor)
is the same as that shown in the Automatic Calibration
section (3.9). Once that process has nished (providing
woofer systems are active in the group), you will be
directed to the woofer system calibration page.
1. The rst step is to pair the monitors to the respective
woofer systems. This is done by rst single-clicking on
the woofer system and then single-clicking on the
monitor it should be paired with. This process is
repeated for all woofer system + monitor pairs in the
Group. Once paired, the pairing will continue to other
Groups.
2. Firstly, the calibration mode is selected by using the
drop-down menu – selecting between Complementary,
1
2
3
1