To Next PageTo Next PageWhy is there no AC output from my Generac Power Systems Portable Generator?
If there is no AC output from your generator, it could be due to the following: * The main line circuit breaker is in the OFF (or OPEN) position. Reset the circuit breaker to ON (or CLOSED).
What to do if my Generac Power Systems Portable Generator engine cranks but won't start?
If your generator's engine cranks but doesn't start, consider these possible causes: * The generator is out of fuel. Refuel the generator and turn on the fuel valve. * Defective spark plug(s). Clean, re-gap, or replace the spark plug(s). * Valve clearance needs adjustment. Adjust the valve clearance.
Why won't my Generac Power Systems Portable Generator engine crank?
The engine might not crank due to several reasons: * A blown fuse. In this case, correct the short circuit condition by replacing the 7.5 Amp fuse. * Loose, corroded, or defective battery cables. If this is the case, tighten, clean, or replace the cables as necessary. * A defective starter contact or motor. If either of these are the reason, tighten, clean, or replace as necessary. * A dead battery. If the battery is dead, charge or replace it.
Why does Generac Power Systems Inverter consume large amounts of oil?
If your Generac Power Systems Inverter is using excessive amounts of oil, it could be related to: * Overfilled oil tank: Adjust the oil level to the correct amount. * Damaged gasket, seal, or hose: Check for oil leaks.
Why does Generac Power Systems 15 kW EcoGen Inverter engine continue to run when set to OFF?
If your Generac Power Systems Inverter continues to run even when set to OFF, it could be due to: * Incorrectly wired control board: Repair the wiring or replace the control board. * Defective control board: Replace the control board.
Why does my Generac Power Systems Inverter engine start hard and run rough?
If your Generac Power Systems Inverter engine starts with difficulty and runs unevenly, consider these potential causes: * A dirty or damaged air cleaner: Inspect and replace the air cleaner if necessary. * Defective spark plug(s): Clean, check the gap, or replace the spark plug(s). * Incorrect fuel regulator setting: Adjust the fuel regulator to the correct setting. * Incorrect fuel pressure: Confirm that the fuel pressure to the regulator is 10–12 in. water column (19–22 mm mercury) for LP, and 3.5–7 in. water column (7–13 mm mercury) for natural gas. * Fuel selector in the wrong position: Move the selector to the correct position.
What to do if Generac Power Systems 15 kW EcoGen Inverter cranks but will not start?
If your Generac Power Systems Inverter engine cranks but doesn't start, it might be due to: * Lack of fuel: Replenish the fuel supply and ensure the fuel valve is open. * Defective spark plug(s): Clean, check the gap, or replace the spark plug(s). * Valve clearance issues: Adjust the valve clearance to the correct setting.
General| Power Output | 15 kW |
|---|---|
| Type | Standby Generator |
| Automatic Start | Yes |
| Voltage | 120/240V |
| Frequency | 60 Hz |
| Dimensions | 48 x 25 x 29 inches |
| Phase | Single |
| Engine Type | Generac OHVI |
| Warranty | 5 years |
| Fuel Type | Natural Gas or Liquid Propane |
Emphasizes understanding the manual for safe operation.
Covers general safety rules, hazards, and warnings for operation and maintenance.
Importance and schedule for routine maintenance tasks.
Common engine problems, causes, and solutions.
Common generator problems, alarms, and solutions.
Troubleshooting specific G-Flex™™ alarms and diagnosing symptoms.
