Models FL3100/3101
23
6.0 Trouble Shooting
6.1 Trouble Shooting
CAUTION -
Component level repair must be undertaken either by General
Monitors personnel or by competent authorized service engineers. SMT PCB
repair shall only be performed at a GM facility.
Introduction
Included in this section is a trouble-shooting table. The information included is
designed to cope with the more common faults, which occur during
commissioning and operation and which are repairable by a competent operator.
Should the various actions suggested in the table fail to restore normal operation,
the unit should be returned to General Monitors for repair. A complete written
description of the problem should be included.
Be sure to inhibit or disconnect external alarm wiring before making any check
which might send the unit into alarm, if an alarm condition will cause a problem.
NOTE -
On no account should repair of the electronic circuit be undertaken by
anyone other than General Monitors’ personnel or authorized representative.
Failure to comply with this requirement will invalidate the warranty.
To Next Page
