6.3 Nitrox Settings
Nitrox Settings
To access： From SETTINGS, press the UP or DOWN
buttons until the pointer aligns with NITROX. Press
the MODE button once.
The Oxygen percentage value at the bottom of the
screen will start blinking. Switch the option with
the UP or DOWN buttons & once the desired
Nitrox option appears ,select it by pressing the
MODE button once to accept the value. The
computer will recalculate the MOD and will be
presenting NDL values corresponding with the
EANx and PO2 values previously set.
You may set the EANx range from 21% to 56%. For
air diving calculations please make sure the
computer is set at 21%.
Notes : Please make sure you have measured the
EANx gas of the cylinder you are about to dive with
and correctly input that value in your computer.
Before using NITROX, you MUST have received
proper training and a certification that qualifies you
to use such gas. Diving with Oxygen enriched mixes
carries an additional layer of risk.
To Next Page
Loading...