4
reading enter 32% in the dive computer’s settings. For a 32.5% enter 33%. The 0.5% fraction will
be your tipping point to round up or down. Incorrect O2 entered values will either
underestimate or overestimate the oxygen/nitrogen gradients inside the diver’s body, affecting
both Oxygen toxicity and Nitrogen build up estimations. Again, only dive with EANx mixes if you
are certified to do so.
2.0 Getting Started Guide
2.1 Maintenance
Particularly after using your computer in salt water, soak your dive computer in fresh water for 5
– 10 minutes to dissolve minerals and then rinse it with running fresh water, but not at very high
pressure. Remove it from the water, shake off the excess of water & wipe it off with a soft
cotton cloth or paper towel.
Avoid using any kind of solvent other than fresh water. Solvents may permanently affect the
watch finish and may even affect the seals compromising the computer’s physical integrity.
Avoid taking apart your dive computer. Opening it or tampering with the internal components
will automatically void your warranty.
2.2 Battery
Your Genesis Centauri dive computer comes equipped with a pre-assembled & sealed
rechargeable lithium battery. Do not attempt to open your dive computer, puncture it, short the
contacts, throw the computer into the fire, expose it to a source of high heat, high electric
current or crush it. The risk of fire or explosion may result if the computer is tampered with.
Consult with Genesis Scuba regarding battery replacement and recycling.
Locate the charging clip and charging USB cable provided with your Genesis Centauri dive
computer. Connect the USB cable to any qualified source with an output of 5.0v at 1.0 – 1.5
mAh such as a USB mobile phone charger or a USB outlet from a laptop computer. Do not use
chargers that are not qualified or that you have doubts about the mentioned voltage and
amperage outputs.
Connect the micro USB portion of the cable to the Centauri proprietary charging clip.
At the charging clip, locate the 4 brass colored metal pins. At the Centauri computer, locate the
corresponding connection points, (4 flat circular, and brass colored contacts) & make sure they
are clean, free of debris, mineral build up or corrosion. Clean the contacts with denatured
alcohol and a cotton swab if needed.
Squeeze the clip to open it & guide it to the watch. Ensure the 4 contact points on the clip are
pointing down and match with the corresponding 4 circular contacts points on the watch. For
To Next Page
Loading...