Driver assistance system
7-32
Blind- Spot Safety system
Malfunction and Limitations
Blind- Spot Safety system
malfunction
OTM070099N
When Blind-Spot Safety system is not
working properly, the ‘Check Blind-Spot
6DIHW\V\VWHPŔZDUQLQJPHVVDJHZLOO
appear on the cluster, and the system will
turn off automatically or the system will
be limited. Have the vehicle inspected by
an authorized retailer of Genesis Branded
products.
OTM070100N
When the side view mirror warning
light is not working properly, the ‘Check
VLGHYLHZPLUURUZDUQLQJOLJKWŔZDUQLQJ
message will appear on the cluster. Have
the vehicle inspected by an authorized
retailer of Genesis Branded products.
Blind- Spot Safety system disabled
OTM070098N
When the rear bumper around the rear
corner radar or sensor is covered with
foreign material, such as snow or rain,
or installing a trailer or carrier, it can
reduce the detecting performance and
temporarily limit or disable Blind-Spot
Safety system.
If this occurs, the ‘Blind-Spot Safety
V\VWHPGLVDEOHG5DGDUEORFNHGŔZDUQLQJ
message will appear on the cluster.
The system will operate normally when
such foreign material or trailer, etc.
is removed, and then the engine is
restarted.
If the system does not operate normally
after it is removed, have the vehicle
inspected by an authorized retailer of
Genesis Branded products.
WARNING
ś Even though the warning message
does not appear on the cluster, Blind-
Spot Safety system may not properly
operate.
ś Blind-Spot Safety system may not
properly operate in an area (e.g. open
terrain) where any substance are
not detected right after the engine
is turned on, or when the detecting
sensor is blocked with foreign
material right after the engine is
turned on.
To Next Page
Loading...
Need help?
General
