3. Press the ↵ (Edit) key. The screen will
change and prompt the engineer to
confirm the selection. Press the ↵ (Edit)
key to continue.
4. The LCD will display the screen as shown.
In the background the software is updating
all pre-loaded parameters relating to
serving a 7oz drink.
5. Once the software has completed updating the timer values the screen will
change and display the message Update Complete. Press the X (Exit) key
twice to return to the Product Configuration screen.
4.5.6 Water Compensation (Espresso Machines)
This sub menu allows the engineer to finely “tune” the bean to cup water
system to compensate for varying operating conditions - type of beans, grind
particle size, water flow etc.
Important! The
Grinder Calibration (see page 42) MUST be carried out
before adjusting the Water Compensation.
Each drink type has water level compensation enabling tuning of the freshbrew
and espresso drink types available from the machine. To adjust the water
compensation values, proceed as follows:
1. From the Product Configuration menu
highlight Water Compensation and press
the ↵ (Edit) key to access the menu
screen as shown. Using the
▲ (up) or ▼
(down) keys, scroll through the menu until
the required drink type is highlighted e.g.
Esp Compensation for espresso and espresso based selections. Press the ↵
(Edit) key to access the menu.
2. The LCD will display the screen as shown
opposite where 160 is the default value for
espresso selections, set when the machine
leaves the factory. The following examples
describe how to adjust this setting if
required.
Technical Manual
40
To Next Page
Loading...
Need help?
General