To configure this value:
1. From the Monetary menu press the
▼
(down) key to highlight Change Without
Purchase and press the ↵ (Edit) key. Enter
the required value, e.g. press 0-1-0-0 using
the drink selection keypad to set a change
without purchase value of £1.00. To
specify Force Vend, set a value of 00.00.
2. Press the ↵ (Edit) key to save the new value and return to the Monetary
menu. Verify that the entered value is displayed in the status line at the
bottom of the display when Change Without Purchase is highlighted.
Configure Low Change Message Value:
N.B. This option is only applicable when an MDB coin mechanism is fitted and
configured from within the Coin Mechanism menu.
When the total value of the coins in the coin mechanism falls below the value
set in the Low Change Message menu, the standby message displayed on the
LCD will read ‘Use Exact Change’.
To configure this value:
1. From the Monetary menu press the
▼
(down) key and highlight Low Change
Message and press the ↵ (Edit) key. Enter
the required value, e.g. press 0-1-0-0 using
the drink selection keypad to set a low
change message value of £1.00.
2. Press the ↵ (Edit) key to save the new value and return to the Monetary
menu. Verify that the entered value is displayed in the status line at the
bottom of the display when Low Change Message is highlighted.
N.B. The machine will still accept money with this value set, but may
short change the customer if there is insufficient coinage in the coin
mechanism. Set the Low Change Message and the Accept on Low Change
values (see below) to the same figure to eliminate any chance that the
customer will be short changed.
Configure the Accept on Low Change Value:
N.B. This option is only applicable when an MDB coin mechanism is fitted and
configured from within the Coin Mechanism menu.
Technical Manual
54
To Next Page
Loading...
Need help?
General