When the total value of the coins in the coin mechanism falls below the value
set in the Accept on Low Change menu, the machine will stop accepting coins
and notes for which it cannot return change. For example, if the engineer sets a
value of £1.00, the machine will not accept £1 coins if there is less than £1
value of coins in the coin mechanism.
To configure this value:
1. From the Monetary menu press the
▼
(down) key to scroll down and highlight
Accept on Low Change and press the ↵
(Edit) key. Enter the required value, e.g.
press 0-1-0-0 using the drink selection
keypad to set a value of £1.00.
2. Press the ↵ (Edit) key to save the new value and return to the Monetary
menu. Verify that the entered value is displayed in the status line at the
bottom of the display when Accept on Low Change is highlighted.
Configure Credit For Failed Vend Option:
N.B. This menu is only available when an MDB coin mechanism is fitted and
configured from within the Coin Mechanism menu.
This option specifies how the machine will react when a vend fails. The
engineer can set one of two options:
(i) Hold Credit: With this option selected the customers credit is
retained, allowing them to either make an alternative selection or
press the coin return.
(ii) Return Change: With this option selected the customers change is
immediately returned after a failed vend.
1. From the Monetary menu press the
▼
(down) key and highlight Credit For Failed
Vend and press the ↵ (Edit) key. Using the
▲ (up) or ▼ (down) keys, select the
desired option (indicated by the filled
radio button).
2. Press the ↵ (Edit) key to save the selection and return to the Monetary
menu. Verify that the chosen option is displayed in the status line at the
bottom of the display when Credit For Failed Vend is highlighted.
Configure Card Revalue:
Not applicable for Genesis machines.
Accept on Low Change
0-9 to Edit Value
EDIT when Finis hed
01.00
Credit For Failed Vend
Hold Credit
Return Change
Technical Manual
55
To Next Page
Loading...
Need help?
General