Genevac HT-8 & HT-12 Series II Evaporating Systems
Page 6 of 64 04-4541 Issue 1-9 – June 2008
Amendment Control Form
Revision
Number.
Issue and Reason for Change Date Issued
1 Introduction of Warranty Statement 26 April 2004
2 Changes to Declaration of Conformity. 21 September 2004
3 Additional Technical Information regarding Power Supplies 11 November 2004
4 Information on the correct use of SampleGuard Probes 28 September 2005
5 Introduction of Auto Defrost and Drain Option 19 September 2006
6 Introduction of Annex A – Getting the best from Auto Defrost and Drain 15 September 2006
7 Converted to A5 Booklet 08 December 2006
8 Add Maintenance of Rotor, Swings and Sample Holders 09 April 2008
9 Update page footers 09 June 2008
1.1 Safety symbols
The following safety symbols are used throughout this manual. The definitions and scope of each symbol is
as described below.
WARNING
THIS SYMBOL INDICATES HAZARDS THAT CAN LEAD TO SERIOUS MATERIAL
DAMAGE OR POTENTIAL SERIOUS INJURY.
Caution
This symbol provides information about hazards that can be harmful to your
health or lead to material damage.
Note
This symbol provides information about technical requirements, which if not followed,
can lead to malfunctions, inefficiency and reduced productivity.
This symbol indicates that there may be a risk to sample integrity.
Genevac Evaporators and Combustible Solvents
Please note it remains the responsibility of the user to consider safety when evaporating any combustible
solvents and ensure the system is placed in a well ventilated environment. Genevac's position regarding
evaporation of such solvents, particularly with respect to the European ATEX directive, is available on our
website or from your local sales representative.
IMPORTANT
THIS SYSTEM MUST BE
EARTHED – SEE PAGE 53
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
