Genie IS User Manual

6_
Attach "middle" rail section [3B].
• Select "middle" rail section. (This section
books identical on both ends with each set of
holes being about 4 inches apart.) Fig. 1-6.
• Find arrows stamped into side of rail.
Fig. 1-7.
• Align rail so arrows point away from
power head.
• Slide screw toward power head so it sticks
out end of rail section about 2 inches.

Genie IS Specifications

General

Type	Chain Drive
Horsepower	1/2 HP
Battery Backup	No
Voltage	120V
Security	Rolling Code