BLIZZARD 400-800 C ENC 11 532104 - Rev.A
1
2
3
1
4
5
6
7
8
5
Translation of the original instructions
ENGLISH
5. INSTALLATION
5.1 TOOLS REQUIRED
!
Use appropriate tools and equipment in working environments which
comply with applicable legislation.
8 Symbols: work tools
17 - 13 - 10 - 8
HEX SPANNER of size indicated
x.x Nm
TORQUE WRENCH - if necessary for safety, a torque wrench and the
TIGHTENING TORQUE will be specified E.g.: HEX WRENCH 6 set at 2.5 Nm
6
2.5 Nm
ELECTRICIAN'S SCISSORS
6.5 - 5.5 - 3.6
HSS DRILL BIT of specified sizes
M8
THREAD CUTTER of specified sizes (for steel rack to be screwed on)
LEVEL
1 Mains power supply 3 x 1.5mm
2
2 Circuit breaker
3 Junction box
4 Blizzard gearmotor
5 Bus G-Way TX photocell
6 Bus G-Way RX photocell
7 Key switch
8 Flashing light
4.3 EXAMPLE SYSTEM
The example is purely an illustration and is only one of the possible applications of the BLIZZARD 400-800 C ENC.
TAPE MEASURE
SCREW CLAMP
WELDER (for steel rack to be welded on)
ANGLE GRINDER
0 1 2 3 4 5 6
CALLIPER
WIRE STRIPPER/TERMINAL CRIMPER
2.5
FLAT SCREWDRIVER of the size(s) indicated
2.5
PHILLIPS SCREWDRIVER of the size(s) indicated
T20 - T15
TORX SCREWDRIVER of the size(s) indicated (electronic board)
To Next Page
Loading...
General