5.
Press the SEEK right or left arrow, or the TUNE
right or left arrow and
0000
will appear on
the display.
6,
Press the
SEEK
left arrow and hold
it
until
the first
digit of your code appears. Release the button.
7.
Press
the
SEEK
right arrow and hold
it
until the
second digit of your code appears. Release
the button.
8.
Press the TUNE
left
arrow and hold it
until
the third
digit
of
your code appears. Release the button.
9.
Press the TUNE right arrow and hold
it
until
the
fourth
digit
of
your code appears. Release
the button.
10.
Press AM-FM after you have checked that the code
you entered
is
the one you wrote down. Then,
REP
will appear on the display which means you need to
repeat Steps
5
through
9.
11.
Press AM-FM again and
the
display will now
show SEC.
Disabling the Theft-Deterrent Feature
If your radio is secured (SEC shows on the display) and
you wish to disable it, enter your security code as follows,
pausing no more than
15
seconds between steps.
1.
2.
3.
4.
5.
6.
i.
Press the
1
and
4
buttons together. Hold them down
until
SEC shows on the display. You are now ready
to
enter your security code.
Press the SEEK left arrow and hold it until the first
digit of your code appears.
Press the SEEK right arrow and hold
it
until the
second digit of your code appears.
Press the TUNE left arrow and hold it until the third
digit of your code appears.
Press the TUNE right arrow and hold it until the
fourth digit
of
your code appears.
Press AM-FM after you have checked that the code
you entered matches the one you wrote down and
0000
should now appear on the display.
You
will
need to repeat the above procedure.
If
the code is correct, the radio will now operate.
If
the
code
is
wrong, ERR will appear on the display.
3-16
To Next Page
Loading...
Need help?
General
