Yhrn Signal and
Lane
Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a
turn
or a lane change.
To signal a turn, move the lever all the way
up
or
down.
When the
turn
is finished, the lever will return automatically.
Q
An arrow on the instrument
panel will flash in the
direction of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until
you
complete your lane change. The lever will return by
itself when
you
release it.
As
you
signal a turn or a lane change, if the arrows don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb
is
burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check the fuse (see
“Fuses
and Circuit
Breakers”
in
the Index) and for burned-out bulbs.
2-30
To Next Page
Loading...
Need help?
General
