I
Part
C:
Periodic
Maintenance
Inspections
Listed below are inspections and services which should
be performed at least twice a year (for instance, each
spring and fall). You should let your
GM
dealer’s
service department or other qualified service center do
these
jobs.
Make sure any necessary repairs are
completed at once.
Proper procedures to perform these services may be
found in a
GM
service manual. See “Service and Owner
Publications” in the Index.
Steering, Suspension and Front Drive Axle
Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged, loose
or
missing parts, signs of
wear
or
lack
of
lubrication.
Inspect the power steering
lines and hoses
for
proper hook-up, binding, leaks,
cracks, chafing,
etc.
Clean and then inspect the drive
axle boot seals for damage, tears or leakage. Replace
seals if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body
near the exhaust system. Look
for
broken, damaged,
missing or out-of-position parts as well
as
open seams,
holes, loose connections or other conditions which could
cause a heat build-up in the floor pan or could let
exhaust fumes into the vehicle. See “Engine Exhaust” in
the Index.
Radiator and Heater
Hose
Inspection
Inspect the hoses and have them replaced if they are
cracked, swollen
or
deteriorated. Inspect all pipes,
fittings and clamps; replace as needed.
7-53
To Next Page
Loading...
