Flash-to-Pass
With the lever
in
the low-beam position, pull the lever
toward you to momenrarily switch to high beam (to
signal that
you
are going to pass). When you release the
lever, the headlamps will return to low-beam operation.
Windshield Wipermasher Lever
The lever on the right side of the steering column
controls the windshield wipers and washers.
Move the wiper switch to the position you want:
OFF:
The wipers are off.
INT
Intermittent wiper operation. In light rain
or
snow,
you might want to use this position rather than
continuous wiping.
LO:
The wipers will run continuously at low speed.
HI:
The wipers will run continuously at high speed.
For
a
single wiping cycle, pull the lever toward you.
Hold it there until the wipers start, then let go. The
wipers will stop after one cycle. If you want more
cycles, hold the lever longer.
Be sure to clear ice and snow from the wiper blades
before using them. If they’re frozen to the windshield,
carefully loosen
or
thaw them.
If
your blades do become
damaged, get new blades or blade inserts.
Heavy snow
or
ice can overload your wipers.
A
circuit
breaker will stop them
until
the motor cools. Clear away
snow or ice to prevent an overload.
2-32
To Next Page
Loading...
