Offline Operation
4-30 Diagnostic Tests
TO PERFORM DIAGNOSTIC PLOTS TESTS
1. From page one of the Diagnostics menu, press F1-Diag Plots to display
page one of the Diag Plots menu.
2. Press the Menu key to display the Diag Plot page that lists the test you
want.
3. Press the function key associated with the test you want to perform. A
screen similar to the one shown below displays when you choose a test.
4. When you have chosen a test, do one of the following:
• Press F1-Start to run this for test one full cycle.
OR
• Press F2-Continuous to run this test until you press F4.
TEST NAME
START
CONTINUOUS EXIT
To Next Page
Loading...
