Welcome
Thank you for purchasing the Mist Coolant Option for your Sabre
router. This
option sprays a fine lubricant mist on the cutting tool to cool and lubricate it
when cutting metals such as aluminum and brass. You do not use it when cutting
non-metallic materials such as wood or plastic.
About this booklet
This booklet provides a list of the kit contents and instructions for installing and
using the Mist Coolant Option. Special information in this booklet is presented
in notes, cautions, and warnings as follows:
T
Note: A note contains important information which could affect successful
completion of a task.
T
CAUTION: A caution statement contains information which, if not
observed, could result in damage to the equipment.
T
WARNING: A warning statement contains information which, if not
observed, could result in personal injury.
Getting help
If you have questions regarding the installation or use of the Mist Coolant
Option, please contact the Gerber Router Support Group at:
860-528-1028
860-290-5568 (fax)
Kit contents
The Mist Coolant Option kit contains the following:
T
coolant control panel with flex lines and attaching hardware
T
coolant tank kit with filter, cap plug, retainer and attaching hardware
T
1 tie wrap
T
1 gallon of TRIM
mist coolant
T
flex line support bracket with mounting screw and washer
To Next Page
Loading...
Need help?
General
