Getinge Lucea 100 Maintenance Manual

4
Maintenance and inspection procedures
Tools required for maintenance
14 / 44
Lucea 50_100
01740 EN 01
4 Maintenance and inspection procedures
CAUTION!
Risk of equipment damage
If adjustments are made incorrectly or not at all, the lighthead or installed
equipment may drift.
Make all adjustments (balance, stop and brakes) during installation and then
after all maintenance operations.
WARNING!
Risk of injury
If the spring arm is not released before the component is removed, it may
spring up abruptly and pose a safety hazard.
Before installing or uninstalling the component, adjust the top limit stop on
the spring arm to the horizontal position. Set the spring arm in the horizontal
position to remove the component.
NOTICE
After-sales service kits are available on the LinkOne spare parts platform.
The LinkOne platform is accessible on the GetingeOnline portal:
getingeonline.com/SIS/external-links
4.1 Tools required for maintenance
Description Qty Part number
OPM 039 Photometer 1 5.720.34,999
OPM 059 Multimeter M 54 RMS 1 5 720 59 999
OPM085 Angled, insulated pliers (for regulation board fuse) 1 6 870 000 11
4.2 Periodic replacements
4.2.1 Periodic replacement cycles
To ensure safety and performance, please follow the recommendations below.
Items Frequency
All brakes Every year
Suspension mounting screws
(tighten the screws to the recommended tight-
ening torque)
Every six years
Bushing mounting screws
(tighten the screws to the recommended tight-
ening torque)
Every six years

Getinge Lucea 100 Specifications

General

Brand	Getinge
Model	Lucea 100
Category	Medical Equipment
Language	English