SERVICE MANUAL ProSeal Classic/Plus/Premium
22
Pic 29
Check all functions. After replacing the control board, the speed, temperature and
pressure should be revalidated. For the ProSeal Classic the speed and temperature
should be validated. For instructions how to validate see section 5.
.
4.3 Assembling
Clean the parts and the lower housing of the unit with compressed air and
surface cleaner.
4.3.1 Heating elements
Turn the heat element upside down and place it in the isolation (Pic 30).
Pic 30
Place the heat element and isolation on the suspension of the base frame
(Pic 31).
To Next Page
Loading...