SERVICE MANUAL ProSeal Classic/Plus/Premium
4
1 General notes
This manual provides the user with the appropriate instructions for safe and proper
maintenance and repair of the sealing unit. Each person involved in maintenance or
repair of the sealing unit must be familiar with these instructions or the safety
regulations respectively. In order to avoid operating errors and to ensure trouble-free
operation of the sealing unit these instructions must always be accessible for the
personnel. By receiving this document you do not automatically participate in an
updating service.
Copyright
This maintenance instruction manual must only be handed over to third parties with
the written consent of GETINGE. All documents are protected by copyright law.
Disclosure as well as reproduction of documents, even in form of excerpts, utilization
and announcement of its content is prohibited, if not explicitly admitted. Violations are
liable to prosecution and oblige to compensation. We reserve the right for the
exercise of industrial property rights.
Warranty and liability
We assume liability for possible faults or omissions within the framework of the
specified warranty obligations, under exclusion of further claims.
In the course of further development we reserve the right for technical modifications
to the sealing unit, which is subject of these maintenance instructions.
We will not assume liability for any damage or malfunction caused by operating
errors, negligence of these maintenance instructions or inappropriate repairs. We
would like to point out that only genuine spare parts and accessories from GETINGE
which have been approved by us should be used.
The installation or use of spare parts or accessories which have not been approved,
will lead to the exclusion of any liability of GETINGE for damage resulting from this.
Technicians preferably should be trained by Getinge Academy.
Drawings and graphical presentations are not to scale.
For maintenance work it is necessary to open the housing.
During maintenance and repair work the unit must be disconnected from the power
supply!
To Next Page
Loading...
Need help?
General
