GEW e-Brick 9kW - Product Information and Specifications; e-Brick Overview, Applications, and Prohibitions; Internal Fuses and Safety Features

4. Product information
4.1. Description of the e -Brick
The e -Brick is a highly integrated power supply designed specifically for powering GEW UV
lamps in drying systems. The
e -Brick features integrated controls and all necessary hardware to
control the UV system including lamp cooling, safety interlock features, and a press interface
allowing the UV curing to be controlled automatically.
4.2. Applications
The e -Brick is specifically designed for powering GEW UV dryers and, in certain applications, IR
dryers; contact GEW for details of compatible UV and IR dryers.
Warning! System efficiency and safety may be compromised and/or the e -Brick may be
damaged by the use of non-genuine GEW UV lamps or dryers.
4.3. Prohibited usages
All applications, other than those specifically detailed in 4.2 above are prohibited.
Please contact GEW for engineering support for all other applications.
4.4. Safety features
Warning! To avoid accident or injury, do not attempt to bypass any safety function.
The e -Brick is designed to be safe in normal operation and to ‘fail safe’ in the event of adverse
operating conditions or internal failure. The following safety features are included:
4.4.1. Internal fuses
Warning! Fuses are not user serviceable; GEW authorised personnel should carry out
replacement.
Mains input
9/12kW 25A/phase 38mm *10mm ceramic fuses, type CC
GEW part 32554
22kW (Europe) 63A MCB type D and Residual Current Device (RCD)
22kW (Canada) 45A/phase 27mm * 60mm ceramic fuses, type J
[33276 / 33485] GEW part 33318
Inrush protection, where fitted
9/12/22kW 600V 6.3A 31.75mm * 6.35mm delay (T) ceramic fuse
GEW part 33890
22kW (Canada) 600V 6A 38mm *10mm ceramic fuse, type CC
[33276 / 33485] GEW part 33888
GEW UV
e -Brick installation and operating manual 19 of 49