GEZE ECturn User Manual

ECturn & ECturn Inside
13
Operation
4.1.3 Selecting the mode of operation using the keypad programme switch
X
The desired operating status is selected by pressing the
and
push buttons.
The LED of the current operating state lights up.
The exit only push button
is not assigned.
When using a key switch:
X
Enable by operating the key switch once briey.
Disable the operation of the keypad programme switch:
X
Activate the key switch briey again.
à If operation of the TPS is not possible since the block is
active, the current mode of operation LED ashes once if a
button is pressed.
Keypad programme switch TPS
Fault messages in the keypad programme switch
à LEDs (1) for mode of operation display an error code if a
fault occurs.
à If there are one or more errors, these are displayed consec-
utively alternatively with the current mode of operation in
encoded form with the ve LEDs. At least two LEDs always
light up when an error is displayed. The mode of operation
is displayed for 5 s, the respective error message for 2 s.
X
Read o the error code, note this down and inform a ser-
vice technician
When the keypad programme switch is used it is still possible to change the mode of operation using the
mode of operation button even when the key programme switch is disabled.
4.1.4 Selecting the mode of operation using the display programme switch
X
Touch the required mode of operation on the display pro-
gramme switch.
The mode of operation is set and indicated on the display (19).
The exit only push button
is not assigned.
Enabling operation of the display programme switch with key
operated button SCT (optional)
X
Press key operated button SCT briey.
Operation of the display programme switch is enabled.
X
Press key operated button SCT briey again.
Operation of the display programme switch is disabled.
X
If operation of the DPS is not possible because the block is
active, then two horizontal dashes are shown briey.
Fault messages on the display
If a fault occurs in the door system, it is displayed on the display pro-
gramme switch about every 10seconds.
X
Read o the number of the fault message, note it down
and notify the service technician.
OFF
19
Display programme switch
210623_GEZE_ID 196257-00_BHB-ECturn_EN.indd 13 7/18/2021 14:00:32

GEZE ECturn Specifications

General

Brand	GEZE
Model	ECturn
Category	Door Opening System
Language	English