GFI System SYNESTHESIA - Dynamic Tremolo Algorithm; Base Speed and Depth Controls; Tweak: Sensitivity to Dynamics; Secondary Control Options

UserManual
SYNESTHESIA

(FirmwareV1.0.2)
5
where to save?
A <push> B
Saveapreset
HolddownXandYencodersuntilapromptappearsonthescreen.




PushfootswitchAtosavetopatchA,orpushfootswitchBtosavetopatchB





BypassthePedal
TapfootswitchA/YorB/X,whicheverpresetiscurrentlyactive(correspondingLEDison).
Afterpresetissaved,thepreset’stitlecanbechangedinOptions(Options‐>TitleEditor)
1.3NAVIGATINGTHEALGORITHMS
TurntheXEncodertoselectanalgorithmtoonDSP‐X,andturntheYEncodertoselectanalgorithmtorunonDSP‐Y.
PushtheXEncodertotoggleDSP‐Xonandoff,similiarly,pushtheYEncodertotoggleDSP‐Yonandoff.
02.Harmonic Trem
HCTREM
Algo#
Algolongname
6‐letteralgoshortname
1.4MASTERVOLUME
Asinglecontrolisprovidedtosettheoverallvolumeofthepedal,from‐3dBto+3dB.

TwisttheYencoder,clockwisetoincreasevolume,anti‐clockwisetoreducevolume.
VOLUME (dB) +2
PREV:+1
<Atthispoint,Ifyou’dliketocancelsavingtoapreset:holddowntheXandYencodersagain>
Mastervolumeisspecifiedonper‐presetbasis.
1.5PARAMETERS:PrimaryandSecondary
Each algorithm has up to 6 adjustable parameters. Three parameters are adjusted by turning the SPEED, DEPTH, or
TWEAKknobs,thesearethePrimaryparameters.Theotherthreeareadjustedbytwisting
(hold‐turn)theSPEED,DEPTH,
orTWEAKknobs,thesearetheSecondaryparameters.
OnlyPrimaryparametersmayberampedorcontrolledviaexpressionpedal.
Forin‐depthinformationonthealgorithmspleaseseeaseparatedocumentthatwehaveprepared:
SynesthesiaAlgorithms.pdf