SV200 R200
4/2007© by GLOBAL GARDEN PRODUCTS
F) Checking the oil breather
71 Remove the magneto flywheel [ 6.9.E
].
72 Unscrew the three screws (51) fixing the closing
plate (52).
73 Check that the valve (53) is not broken or dam-
aged and that it can move freely in its housing.
74 Refit the plate (52) with the relative gasket.
75 Refit the magneto flywheel [
6.9.E].
G) Replacing the upper compression ring
of the engine shaft (flywheel side)
81 Remove the magneto flywheel [ 6.9.E].
82 Take out the spline key (61).
83 Use a thin screwdriver inserted under the seal-
ing lip to extract the oil seal ring (62).
84 The new ring (63) must be inserted with the help
of a pipe (64) with a diameter of approximately
50-55 mm, taking care not to damage the seal-
ing lip.
85 Refit the magneto flywheel [
6.9.E].
6.9.1
ENGINE BLOCK – External operations
6 / 7
SERVICE MANUAL
page
from
2007 to ••••
51
51
51
52
53
61
62
63
64
To Next Page
Loading...
Need help?
General
