Installation Manual Series CF (excluding encapsulated screw compressors) 23042013 Rev. A / May 2007 4 of 60
1 General
1.1 Intended purpose
GHH RAND manufacture and supply the Series
CF compressor stages as built-in elements for
compressed air generation systems or packages.
The compressors are exclusively intended to
compress air within the scope of the specified
technical applications limits.
Any other utilization of compressor beyond these
applications is not usual. The manufacturer is not
liable for resulting defects! The operator is re-
sponsible for the risk only!
For differing utilisation the approval of the
manufacturer is required.
1.2 Type designation
Designation is structured as follows:
G Integrated gear
L Extended rotor profile
D Direct drive
R Belt drive
Rotor center line distance in mm
Series
1.3 Marking
The type designation is to found on the compres-
sor’s nameplate.
The whole marking has docu-
mentary value and shall not be
removed, modified or made il-
legible.
1.4 Information required for inquir-
ies and orders
When inquiring about and ordering spare parts
and accessories, please state the exact type des-
ignation and the machine number of the com-
pressor.
Required wear- and tear part kits for mainte-
nance in chapter 7.
Original spare parts and
accessories approved by the
manufacturer contribute to
safety.
The use of non GHH RAND
spare parts and or non-approved
accessories will result in the loss
of any liability for the
consequences arising there-
from.
1.5 Sale and service point
Addresses of the sale and service points are to
be found at the end of this installation manual
(section 7).
To Next Page
Loading...