Installation Manual Series CF (excluding encapsulated screw compressors) 23042013 Rev. A / May 2007 6 of 60
Local condition rules & regulations and especially
safety regulations must be adhered to in full. In
the event of concurrent regulations, please al-
ways comply with the most stringent.
2.5 Safety instructions for the oper-
ating company/operator
The operating company is responsible that the
compressor is always in safe operating condition.
Damaged or non-operating compressors shall be
replaced without delay.
2.6 Safety instructions for mainte-
nance, inspection and mounting
work
Service and maintenance is only permitted to be
carried out by a GHH RAND authorized service
bureau
The machine/system should only be worked on
whilst shut down and isolated. Following the ma-
chine/system shutdown procedure described in
the operating manual is imperative.
Disposure of oils and greases in accordance with
local legislation is mandatory.
After completion of work, immediately reinstall
and reset into operation all safety and protection
devices.
Before resuming operation, the points mentioned
in section “Putting into operation“ (section 5) shall
be observed.
2.7 Unauthorised conversion and
manufacturing of spare parts
Conversions or modifications of the compressor
are not permitted unless agreed in writing by
GHH RAND.
Original spare parts and accessories approved
by the manufacturer contribute to safety.
The use of other spare parts and non-approved
accessories may result in the loss of liability!
2.8 Unauthorized operation modes
Without written consent of GHH RAND, the com-
pressor shall not be operated under other condi-
tions than those described in annex “Technical
data”.
To Next Page
Loading...