- 27 -
▪ At this point, pressing the MODE key for less than one second, the balance switches
to the standard unit (g) and the display will show the current weight loaded on the pan;
in this case " 250 g ".
Percentage calculation – Example n° 2
▪ Remove the reference sample from the pan and add on a weight of 27,5g: the display
will show " 27,50 % "
▪ Add on an other weight of 122,5g on the pan: the display will show " 150,00 % ".
▪ Adding an other weight of 378g on the pan the display will show the blinking message
“OvEr PErc”. This means that the maximum limit of 500% of the acquired reference
sample has been reached and exceeded.
▪ If the MODE key is now pressed for less than one second, the balance switches again
to the standard unit (g) and the display will show the current weight loaded on the pan;
in this case “ 528 g ” that it’s the 528 % of the acquired reference sample.
▪ Switching back to the percentage weight function, the message “OvEr Perc” will be
displayed again. To cancel it, remove some weight from the pan, and sample again
with another value if needed.
5.4 ENERGY SAVING OPTIONS
The available options for energy saving are:
Pressing the ON-OFF key for less than one second, the backlight of the
display switches off. The balance remains fully operating.
Pressing the ON-OFF key for more than one second, the balance switches
to “stand-by” mode and the display will show "OFF". Press again the ON-
OFF key to switch-on the balance.
From the SETUP menu it is possible to enable the IDLE SET function (see
Sec. 6.2). This function switches-off the display if the balance is unutilised
for more than 10 minutes and the message “Idle State” will be shown. The
balance switches-on automatically when receiving a command from the
keyboard or from the serial and when the pan is moving for any reason.
When the balance is not used for a very long time power it off as described below.
▪ Standard models: unplug the power supply unit from the mains.
▪ BP models: power off using the switch placed on the rear.
At the next power up, wait at least 15 minutes (warm-up) before using the instrument.
ATTENTION !
In the BP models, if you disconnect the power supply without using the switch placed on
the rear, the balance is still powered by batteries.
6. CONFIGURATION MODE
To enable the alternative units, to modify the default configuration and to start the
calibration process, the configuration mode must be activated. To enter in configuration
mode, press the MODE key for more than one second. From this moment the functions of
the keys change as follows:
To Next Page
Loading...
