Gigabyte MZ72-HB0 - Page 61

- 61 - BIOS Setup
2-2-17-1 iSCSI Boot Conguration Menu
Parameter Description
iSCSI General Parameters
Press[Enter]tocongureadvanceditems.

TCP/IP Parameters via DHCP
– Acquires TCP/IP Parameters via DHCP.
– Options available: Enabled, Disabled. Default setting is Enabled.

IPAutoconguration
– Auto-congurestheIPconguration.
– Options available: Enabled, Disabled. Default setting is Enabled.
– ThisitemiscongurablewhenTCP/IPParametersviaDHCPisset
to Disabled.

iSCSI Parameters via DHCP
– Acquires iSCSI Parameters via DHCP.
– Options available: Enabled, Disabled. Default setting is Disabled.

CHAP Authentication
– Enable/Disable the CHAP authentication.
– Options available: Enabled, Disabled. Default setting is Disabled.

Boot to iSCSI Target
– Enable/Disable booting to iSCSI target after log-on.
– Options available: Enabled, Disabled, One Time Disabled. Default
setting is Enabled.

DHCP Vendor ID
– CongurestheDHCPvendorID(upto32characterslong).