Gigabyte MZ72-HB2 - Page 59

- 59 -
BIOS Setup
Parameter Description
MBACongurationMenu
(continued)

Setup Key Stroke
– Congureskeystrokestoinvokethecongurationmenu.
– Options available: Ctrl-S, Ctrl-B. Default setting is Ctrl-S.

Banner Message Timeout
– Selects the timeout value. (0 defaults to 4 seconds, 15 is no delay,
1-14 is timeout value in seconds)
– Default setting is 4.

Pre-boot Wake On LAN
– ConguresPre-bootWakeonLAN(WOL).
– Options available: Enabled, Disabled. Default setting is Disabled.

VLAN Mode
– ConguresthevirtualLAN(VLAN)mode.
– Options available: Enabled, Disabled. Default setting is Disabled.

VLAN ID
– CongurestheVLANID(1…4094).
– This item is available only when VLAN Mode is Enabled.

Boot Retry Count
– Selects the number of boot retries.
– Options available: No Retry, 1 Retry, 2 Retries, 3 Retries, 4 Retries,
5Retries,6Retries,IndeniteRetries.DefaultsettingisNo Retry.
iSCSIBootConguration
Menu
Press[Enter]tocongureadvanceditems.
Blink LEDs
IdentiesthephysicalnetworkportbyblinkingtheassociatedLED.
Pressthenumerickeystoadjustdesiredvalues.
Link Status
Speciesthelinkstatusoftheport.
Physical Link Speed
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
Chip Type
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
PCI Device ID
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
Bus:Device:Function
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
Permanent MAC Address
Displays the MAC address of the Ethernet controller.
Virtual MAC Address
Displays the virtual MAC address of the Ethernet controller.
Restore Defaults
Resets the adapter to factory defaults.