User Guide
GD32E507Z-EVAL
38/43
The ADC monitor page shows as below:
Open the DHCP function in main.h, using a router to connect the board, and use the
HyperTerminal to print the automatic allocated ip address, then connect your mobile phone to
the wifi which the router send. Users can visit the eval board and control it on your mobile
phone.
5.25. USBHS_Device
5.25.1. HID_Keyboard
DEMO Purpose
This demo includes the following functions of GD32 MCU:
Learn how to use the USBHS peripheral mode
Learn how to implement USB HID(human interface) device
The GD32E507Z-EVAL board is enumerated as an USB Keyboard, which uses the native PC
Host HID driver, as shown below. The USB Keyboard uses Joystick to output three characters
(‘b’, ‘a’ and ‘c’). In addition, the demo also supports remote wakeup which is the ability of a
USB device to bring a suspended bus back to the active condition, and the ‘a’ key is used as
the remote wakeup source.
To Next Page
Loading...
