Gigaset A730 - Default Chapter; De-Registering Handsets; Locating Handsets (Paging); De-Register

24
Using the handset
Registering handsets
Manual registration of the Gigaset
A530H on a Gigaset A730 or
If you want to register additional handsets.
you must activate manual registration of the
handset (1) on both the handset (2) and the
base.
When the regist
ration process has
completed successfully, the handset
returns to idle status. The handset's internal
number is shown in the display e.g. INT 1. If
not, repeat the procedure.
On the handset
If the handset is not registered to a base:
§§MENU§§ ¢ SETTINGS ¢ REGISTER HS
§OK§ Press the display key to start the
registration.
On the base
Within 60 seconds, press and hold the regis-
tration/paging key (
¢ page 1) for
approx. 5 seconds.
The speaker key (LED) m flashes and you
will hear a beep.
On the handset
~ Enter the current system PIN
(default: 0000) and press
§OK§.
A message indicates that the system is
searching for a base that is ready for registra-
tion.
De-registering handsets
You can de-register any other registered
handset from any registered Gigaset A530H
handset.
§§MENU§§ ¢ SETTINGS ¢ DE-REGISTER
s Select the internal subscriber
you wish to deregister and press
§OK§.
~ Enter the current system PIN
and press
§OK§.
§OK§ Press the display key to confirm
the action.
Locating handsets (paging)
From the base
You can locate your handsets using the base.
Briefly press the key on the
base.
Al
l called handsets will ring
simultaneously (paging), even if the
ringtones are deactivated.
Ending paging
Press the key again on the base.
Pr
ess the key again on the base (
¢ page 3).
From the handset
You can locate another handset using your
handset.
u Briefly press the INT key (control
key o
n the left).
q Use the control key to select the
handset to be called or selec
t
CALL ALL to locate the base and
all registered handsets.
§OK§ Press the display key to start
paging.
Al
l called handsets and the base wi
ll ring
simultaneously (paging), even if the
r
ing tones are deactivated.
Ending paging
Ý Press the display key to stop
paging.
Please note
If four handsets are
already registe
red,
no additional handset can be registered
to the base. If the 5th handset intends to
register to the base, an error tone is
out put and the display shows
MEMORY FULL!.