33
Connecting the telephone to the PABX
The following settings are only necessary if
your PABX requires them; see the PABX user
guide. The settings can only be made via a
registered handset (
¢ page 24).
Changing the dialling mode
The following dialling modes can be
selected:
u Tone dialling (DTMF)
u Pulse dialling (DP)
§§MENU§§ ¢ SETTINGS ¢ DIALING MODE
q Select the dialling mode and
press
§OK§.
Setting recall
Recall specifies the flash time (break)
used
for tone dialling when a recall (e.g. a consul-
tation call) is activated. Your phone is preset
at the factory for operation on the main
connection. For operation on a PABX, you
may have to change this value. Please refer
to the user guide for your PABX.
§§MENU§§ ¢ SETTINGS ¢ FLASH TIME
q Select the recall time and press
§OK§.
Possible values are:
100 ms, 300 ms, 600 ms.
Setting an automatic prefix
Y
ou can set a prefix which is automatically
added to a phone number with at least 5
digits. This prefix can be used to dial into the
outside line when operating the device on a
PABX. A pause is added automatically after
the prefix.
The number must be dialled in idle mode, i.e.
first
~ then d.
Activating/deactivating the
automatic prefix
§§MENU§§ ¢ SETTINGS ¢ AUTO PREFIX
¢ ACTIVATION
q Select ON or OFF and press §OK§.
Setting the prefix number
§§MENU§§ ¢ SETTINGS ¢ AUTO PREFIX
¢ PREFIX NO
~ Enter the prefix number and
press
§OK§.
Example: AUTO PREFIX = ON and set to 65
Temporarily switching to
tone dialling (DTMF)
If your PABX still operates with dial pulsing
(DP), but you need tone dialling for a
connection (e.g. to listen to a network mail
box) you must switch to tone dialling for the
call.
Requirement: You are conducting a call or
have already dialled an external number.
During the call:
* Press the star key.
After the call i
s ended, dial pulsing is
auto-matically activated again.
You dial Actually dialled number
1234 1234
12345 65P12345
#12345 65P#12345
To Next Page
Loading...
