5.2.7 TRAILS
To activate TRAILS on a preset:
a. Select the preset you want your Reverb and Delay Trails to spill-over onto.
b. Go to TRAILS in the menu.
c. Scroll right and turn on TRAILS for the preset.
d. Select the loop(s) that contain Delay and/or Reverb, to enable the spill-
over function for these pedals.
Remember, you set up Trails on the preset you are going to, not the preset
that you have come from.
5.2.8 PARALLEL
The G3 Atom’s PARALLEL FUNCTION enables you to split your signal path in two, meaning you can set up
effects in Parallel, Wet Dry, and even send different effects to different amplifiers.
The G3 Atom allows you to flip the phase of the parallel signal chain. This is important for resolving phase
cancellation between the two signal paths. If the effect is out of phase you will hear a cancellation/reduction of
frequency/volume. An example of this would be setting up a parallel signal path with no effects selected and
then flipping the phase in G3. You would hear a complete cancellation of your guitar signal.
To Next Page
Loading...
Need help?
General
