SETTING UP PARALLEL
a. In the Deep Edit Menu, scroll down to PARALLEL.
b. Scroll right to turn on PARALLEL ENABLE.
c. Use PARALLEL START to select where the signal path splits
(i.e.before Loop 1).
d. Use PARALLEL END to select where parallel signal rejoins.
e. If no join is selected the parallel signal path will be sent to OUTPUT 2.
f. Next, you need to select the loops you want to add to your Parallel Signal Path using the PARALLEL
LOOPS option.
g. Use PHASE SETTINGS to resolve any phase cancellation.
EXAMPLE 1 - PUTTING AN OVERDRIVE AND DISTORTION IN PARALLEL
Here’s how you would set up this signal path:
a. Enter Deep Edit Menu and scroll down to Parallel.
b. Select Parallel Enable then Parallel Start and set to after Loop 1.
c. Now select Parallel End, then select before Loop 6.
d. Select Parallel Loops then engage Loop 2.
e. Now use the Phase setting to correct any phase cancellation issue between loop 2 and loop 3.
To Next Page
Loading...
Need help?
General
