EXAMPLE 2 - WET / DRY
The concept of a Wet/Dry setup is to send your Gain/Tone shaping effects (which form the dry signal chain) to
one amplifier and sending the whole signal chain including Modulation, Delay and Reverb effects (forming the
wet signal chain) to a second amplifier.
To set up this Wet Dry signal path:
a. Scroll down to Parallel and select Parallel Enable.
b. Select Parallel Start and select after Loop 3.
c. Select Parallel End and Select NO JOIN.
d. Select parallel Loops and select Loops 5 & 6.
EXAMPLE 3 - PARALLEL WITH STEREO
This is basically the same as your Wet/ Dry rig, where you do not have a join after you split the signal. Any
stereo effects that you add from this will be added into the signal path, keeping the signal path separate. It’s
important that the effect be true stereo with LEFT and RIGHT inputs.
To Next Page
Loading...
Need help?
General
